OPERATIONAL CONTROLS
Operation - 25
Seat Latch Strap (S)
The seat latch strap secures the seat during trans-
port of the power unit.
To secure the seat, place the tab on the end of the
seat latch strap over the seat latch pin. Install the
linch pin through the hole in seat latch pin to secure.
To release the seat so that it can be tilted forward
for service, remove the linch pin and lift the tab on
the seat latch strap off the seat latch pin.
Transmission Neutral Levers (T)
CAUTION
Never shift the transaxles to neutral while under
load, while moving, or while on a slope.
Always place the selector lever in the parking
brake position while shifting into neutral.
Always re-engage both transaxle levers when
pushing or towing of power unit is complete.
0
0
1
1
0. Neutral
1. Transaxle Engaged
In the event the power unit must be pushed or
towed, both the front and rear transaxles must be
shifted into neutral position. Lift up on each lever,
pull the lever out toward you until the tab clears the
frame, and lower the lever back into the frame notch
to secure in the neutral position. NOTE: insert a
screwdriver or other tool through the hole in the lever
to aid in pulling the lever out to the neutral position.
Horn Switch (AA)
Press the horn switch to
1
1
1. Horn
Signal
sound the signal horn. The
horn will sound until the
horn switch is released.
Directional Signal Switch (BB)
1
1
2
2
1. Left Turn Signal
2. Right Turn Signal
Pressing the left portion of the directional signal
switch turns the left turn signal on. Pressing the
right portion of the directional signal switch turns the
right turn signal on. Return the switch to the middle
position to turn the signals off. The left and right turn
signals will override the hazard flashers.
Hazard Flasher Switch (CC)
0. Hazard Flasher Off
1. Hazard Flasher On
0
0
1
1
Pressing the right portion of the hazard flasher
switch flashes both directional turn signal lights.
Pressing the left portion of the switch turns the
hazard flasher lights off. Use of the directional turn
signals will override the hazard flashers until the
turn signals are turned off.
Work Light Switch (DD)
Depressing the front (1) of the
0
0
1
1
0. Off
1. On
work light switch turns the work
lights on. Pressing the back (0) of the switch
turns the work lights off.
Strobe Light Switch (EE)
Pressing the front (1) of the
0
0
1
1
0. Off
1. On
strobe light switch turns the strobe
light on. Pressing the back (0) of the switch
turns the strobe light off.
