8. NON-DUCTED (R
ECIRCULATION
)
(
CONT
’
D
)
8.4 M
OUNT
THE
M
ICROWAVE
O
VEN
(
CONT
’
D
)
NOTES: • If your cabinet is metal, install the nylon strip around the power cord hole to prevent cutting of the cord.
• We recommend using fi ller blocks if the cabinet front hangs below the cabinet bottom shelf.
• When mounting the microwave oven, thread power cord through hole in bottom of top cabinet (
A
). Keep
it tight throughout steps 1-3. Do not pinch cord or lift oven by pulling cord.
1.
Remove the polystyrene packaging and discard.
2.
Lift microwave, tilt it forward, and hook slots
at back bottom edge onto four lower tabs of
mounting plate (
B
).
3.
Rotate front of oven (
C
) up against cabinet bottom.
3.
Insert 2 self-aligning screws (
D
) through top cabinet
holes. Temporarily secure the oven by turning the screws
at least
2 full turns
on each screw after the threads
have engaged.
Ensure to keep power cord tight.
Be careful not to pinch the cord, especially when
mounting fl ush to bottom of cabinet.
4.
Tighten the 2 screws to the top of the microwave oven.
(While tightening screws, hold the microwave oven in
place against the wall and the top cabinet.)
MO0016
B
C
A
MO0018
D
17
CAUTION
If fi ller blocks are not used, case damage may occur from over tightening screws.
MO0017A
C
ABINET
FRONT
C
ABINET
BOTTOM
SHELF
F
ILLER
BLOCK
S
ELF
-
ALIGNING
SCREW
M
ICROWAVE
OVEN
TOP
E
QUIVALENT
TO
DEPTH
OF
CABINET
RECESS
