10
1. Assemble 4 angle brackets to the
ceiling mounting bracket using at
least two no. 10-32 x 1/2" quadrex
screws per angle bracket.
NOTES:
1.
Do not tighten the
screws
yet.
2. Depending on the height
needed
(
C
) (previously
determined in section 4),
the angle brackets might
not touch the ceiling as
illustrated at right.
2.
If required according to table in
section 4, assemble a second set
of 4 angle brackets to the inner
side of the upper angle bracket set
according to the height needed (
C
).
Use at least two no. 10-32 x 1/2"
quadrex screws and two no. 10-32
lock nuts per angle bracket connection.
NOTE: Do not tighten the screws yet.
F
OR
10-
FT
CEILINGS
:
Both lower and upper flues are
included with the hood, but for a
10-ft ceiling, discard the provided
upper flue and use the optional
extension flue, part no. 19325
(sold separately). Four additional
angle brackets and additional moun-
ting hardware are included with the
optional extension flue. If required
according to table in section 4, as-
semble a third set of 4 angle brac-
kets to the second angle bracket set
according to the height needed (
C
).
Use at least two no. 10-32 x 1/2"
quadrex screws and two no. 10-32
lock nuts per angle bracket.
NOTE: Do not tighten the screws yet.
3.
Attach blower box assembly to
lower angle brackets using at least
two no. 10-32 x 1/2" quadrex screws
per angle bracket.
NOTES: 1. Make sure the blower box
bottom is at the desired
height
(
C
) as previously
determined in section 4.
2.
Ensure electrical box is
positioned in the back
right
corner.
6. ASSEMBLE
ANGLE
BRACKETS
HD0444
F
OR
10-
FT
CEILINGS
(
IF
REQUIRED
)
E
LECTRICAL
BOX
