- 9 -
1.
Determine the more convenient location for the control.
The wall control dimensions are:
Depth:1’’ (25 mm)
Height: 4.5’’ (114 mm)
Width: 2.75’’ (70 mm)
2.
Remove the cover plate control (
1
). If you prefer to have your main control mounted on an approved outlet
box or an approved mounting bracket (not included), discard the backplate (
2
).
3.
Take one end of the cable and pass it through the wall control backplate (or outlet box or mounting bracket).
4.
Splice back this end of the cable to access to the 4 wires. Remove the insulated
sleeve of each wire ends. Make a loop with each bare end wire to hook them to the
corresponding screw. Connect YELLOW wire to ‘’Y’’screw, RED wire to ‘’R’’screw,
GREEN to ‘’G’’screw and BLACK to ‘’B’’screw. See illustration beside.
5.
Pass the other end of the cable through the wall. Reinstall the cover plate.Using wall anchors and provided screws, mount the wall
control on the wall. See illustrations below.
1) Wall anchors
4) Control 1) Outlet box
3) Control
2) Control cable
5) Screws 2) Control cable
4) Screws
3) Control backplate
CAUTION
Never install more than one optional wall control per unit.
WARNING
To avoid risk of electrical shocks, never install another wire in the same electrical box than the one for the wall control.
0
!
WARNING
Always disconnect the unit before making any connections. Failure in disconnecting power could result in electrical shock or
damage of the wall control or electronic module inside the unit.
0
!
4. WALL CONTROL INSTALLATION
1
2
BLACK
wire
YELLOW
wire
GREEN
wire
RED
wire
WARNING
Make sure that the wires do not short circuit between themselves or by touching any other components on the wall control.
!
VC0052
VC0051
1
2
3
4
5
2
3
4
1
VC0049
