31
OUTPUT STATUS
Command for OUT1 output status
TEMPERATURE
Command for external temperature notification
SIM EXPIRATION RESET
Command for SIM expiration reset. The countdown for the SIM expiration
is reset at 10 months
SIM EXPIRATION
Command for SIM expiration check
ZONES 1 TO 9 STATUS
Command for zones and radio signal status of the devices according
to the latest signal reception. Send 2 signals before checking for radio
range
ZONES 10 TO 18
STATUS
RESET TO DEFAULT
Command for the reset to default
SOUNDER RESTART
Command for the CTH-18 microprocessor restart
SMS LANGUAGE
Command for the change of the SMS language sent from CTH-18
FLASH ANOMALIES
RESET
Command for the reset of the anomalies signaled by the flashing unit.
When a new anomaly occurs, the flashing unit starts notification again
4. CONFIGURATION AND STARTUP BY SMS
ATTENTION:
FOLLOW THE SPECIFIED MODALITIES TO TYPE SMS, INCLUDING SYMBOLS AND
CHARACTERS. SMS TEXT CAN BE TYPED BOTH WITH CAPITAL AND/OR LOWER CASE LETTERS.
1. Supply CTH-18 with the cover open and connect the battery to its faston terminals. In this way, the
MAINTENANCE MODE (10hours) and the NUMERS UNLOCK (10hours) switch on.
NOTE: MAINTENANCE MODE is useful during the installation and maintenance phase, as it
reduces the acoustic power and limits the duration of the possible alarm to only 5 seconds.
NUMBERS UNLOCK allows to manage and set CTH-18 by any telephone number, whereas it
normally reads only managing controls sent from registered telephone numbers, for which
the option to send managinig control is allowed.
2. Supply CTH-18 220V;
3. The green LED on board flashes to notify GSM signal search. Once the GSM signal is catched, the
green LED lights steady. Verify the correct operation of the GSM and the signal power by sending
GSM STATUS command (see TAB.6);
4. Proceed with the learning of wireless devices and the zones configuration (see REMOTE CONTROLS
and ZONES section on page 32);
5. Configure telephone numbers and the related options (see TELEPHONE NUMBERS on page 34);
ATTENTION
: BY SENDING TELEPHONE NUMBERS TO CTH-18, TELEPHONE NOTIFICATIONS ARE
AUTOMATICALLY ACTIVATED.
6. Configure CTH-18 options (see SOUNDER OPTIONS on page 35);
7. Send STATUS OF ALL ZONES command (see TAB.5) to check for zones status and wireless
