VENGEANCE HYPERION FPV RACER, Manual

Page: 14 / 19

The colored indication bars
in CleanFlight represent
your real time channel PWM
signal. Make sure to turn
your Transmitter ON so you
may check your trim and to
make sure your channels moves in the correct direction.
It is important to note that when you move your Transmitter sticks that your Transmitters Travel Adjustment (ATV)
must move to less than 1100 and more than 1900. If your Transmitters Travel Adjustment is not properly setup
than your Vengeance will not ARM. To ARM your Vengeance move your YAW/RUDDER stick to the Bottom and
RIGHT position for 1-2 seconds. DO NOT ARM Vengeance with propellers on for the first time!
The "Receiver" directory of
CleanFlight helps to show you your
Channel Map and the position
of your Transmitters controls with
respect to the Flight Controller.
Under the "Channel Map"
o p t i o n p l e a s e c h o o s e i f y o u
are using Futaba / Hitec or JR /
Spektrum / Graupner.
DO NOTE! You must "Save and
Reboot" to save changes onto your
flight controller.
MODE 1
Throttle
Roll
Pitch
Yaw
MODE 2
Throttle
Roll
Pitch
Yaw
Channel Map
Default
Futaba
Hitec
JR
Spektrum
Graupner
1 Roll Roll Throttle
2 Pitch Pitch Roll
3 Throttle Throttle Pitch
4 Yaw Yaw Yaw
5 Aux1 Aux1 Aux1
6 Aux2 Aux2 Aux2
7 Aux3 Aux3 Aux3
8 Aux4 Aux4 Aux4
Radio Channel Revers
Futaba
Hitec
JR
Spektrum
Graupner
1 Roll Reverse Throttle Normal
2 Pitch Normal Roll Reverse
3 Throttle Reverse Pitch Normal
4 Yaw Normal Yaw Reverse
5 Aux1 Aux1
6 Aux2 Aux2
7 Aux3 Aux3
8 Aux4 Aux4
Radio End Point / ATV Setting
Futaba
Hitec
JR
Spektrum
Graupner
1 Roll 110/110% Throttle 120/120%
2 Pitch 110/110% Roll 120/120%
3 Throttle 110/110% Pitch 120/120%
4
Yaw 110/110% Yaw 120/120%
5 Aux1 110/110% Aux1 120/120%
6 Aux2 110/110% Aux2 120/120%
7 Aux3 110/110% Aux3 120/120%
8 Aux4 110/110% Aux4 120/120%
Left
Left
Pitch UP (Stick Low)
Low
Gimbal DOWN
Flight Mode Change Flight Mode Change
Gimbal UP
Right
Right
Pitch Down (Stick Hight)
High
12