VENGEANCE HYPERION FPV RACER, Manual

Page: 15 / 19

1
2
1
2
RACE MODE (Default): While in Race Mode the camera will
dampen any oscillations during flight while viewing in the
Vengeances general preset camera view angle. Oscillations
under 0.4seconds will be dampended out. Race Mode is
designed to dampen rapid changes in pitch thus stabilizing
your view.
PPM Receiver and Gimbal Note: While using RACE MODE adjusting the camera angle via PPM is not supported. SELF-LEVEL MODE is not
supported via PPM wire. If you wish to have full-access to your camera gimbal you must use a standard PWM receiver.
9. Gimbal Mode and Settings
Mode Change Button
R
A
CE
M
od
e
(P
re
se
t)
1
2
1
2
SELF-LEVEL MODE (Secondary): While in Self-Level
Mode the gimbal will fully stabilize the camera angle
parralel to the ground. This mode is recommended for
beginners or people wanting a more stabilized view.
SEL
F-L
EV
EL
M
od
e
(P
re
se
t)
How To Change Gimbal Stabilization Modes:
There are two types of gimbal stabilization modes. First mode (by default) is
"Race Mode". The second mode is "Self-Level Mode". To change between
modes quickly press the "Mode Change Button" twice with a small tool.
DO NOTE: Mode switching cannot be remembered by the gimbal
after unplugging the battery. When you unplug the battery from the
Vengeance the gimbal will reset to "Race Mode" by default.
or
Gimbal Down Gimbal UP
T h e V e n g e a n c e u t i l i z e s a
b r u s h l e s s g i m b a l f o r p i t c h
d a m p e n i n g a n d v i e w
adjustment.
1 . W h e n t u r n i n g O N t h e
Vengeance please keep the
Vengeance level and do not
move for about 5 seconds. The
gimbal sensors must detect the
horizontal position.
2.Make sure that the Gimbal's
wires are not tangled and are
able to move freely. Failure
to free the Gimbal head from
obstructions may lead to the
Gimbal motor to fail.
3.W h e n p o w e r i s
plugged in on the
Vengeance if the g
i m b a l v i b r a t e s
a n d o s c i l l a t e s
uncontrollable then reset the
power and power again.
4.After the gimbal is set and
detects horizontal positioning
after 5 seconds you may
rotate the gimbal with your hand to find your
desired camera view angle.
5.Ch.6 on your PWM Receiver can be used to
control the Gimbal rotation UP or DOWN.
13