VENGE VIAS, User Manual

Page: 25 / 36

22
ALTERNATE ROUTING (b):
4b
„
Fig.4b: Route the stem wire out the front of the handlebar.
„
Fig.5b:
Route the three wires through the stem faceplate and the Garmin bracket slot, then plug them into the
Junction A box. Attach the Junction A box to the Di2 mount under the Garmin mount.
5b
Di2 WIRES TO JUNCTION A BOX
JUNCTION A BOX BRACKET
„
Position the handlebar against the stem and install the stem bolts.
„
Install the brake levers on the handlebar drops.
„
Line up the handlebar marks with the stem clamp and line up the levers with the marks on the handlebar. See
Chapter 1, Section A. “DETERMINING FIT”, fig.7, page 9.
„
Trim the brake housings and complete the brake installation according to the brake manufacturer’s instructions.
When trimming the brake housings, it is recommended to trim the housings long enough that when
attached to the brake/shift levers, the excess that gets pushed back inside the handlebar will create
exaggerated curves, which can help prevent rattle between the housings and the handlebar.
„
Place the stem faceplate onto the handlebar (
see fig.8, page 10
) and insert the stem bolts through the
handlebar. Make sure the housings aren’t interfering with the bolts going through the handlebar. The bolts can
be positioned above or below the housings.
„
Before tightening the bolts, align the handlebar rotation position (see fig.7, page 9 ) and make sure it’s
centered left-to-right, then tighten the stem faceplate bolts to 100 in-lbf (11.3 Nm).