VENGE VIAS, User Manual

Page: 23 / 36

20
2
Di2 WIRE
REAR BRAKE
FRONT BRAKE
„
Reinstall the fork in the head tube according to the steps in Chapter 1, Section A. “DETERMINING FIT”, page
7 . Be careful not to move the compression ring, keep it properly seated in the upper headset bearing.
„
Fig.2: Route the front/rear brake housings and the down tube wire up through the spacer stack and the stem shim, then
place the spacer stack on the steerer tube. The spacers are keyed to align with the compression ring and the stem.
„
Fig.2: Place the wire in the shim’s wire channel, then install the shim on the steerer tube.
„
Fig.2: Route the housings and wire up through the stem, then place the stem on the steerer tube.
Mark the brake housings so that it’s clear which is the front and rear housing. If running reverse
brakes (UK), make sure the front housing goes to the drive-side lever.
3
DO NOT KINK!
STEM PORT
Fig.3: Guide the housings and wire through the stem port until they exit at the front of the stem. Support the brake
housings with your fingers to prevent the housings from kinking as they make the bend into the stem. If a housing
gets kinked, it may affect performance and need to be replaced.