Programming Manual
GLASSFRONT VENDING MACHINES
Rev. 1.12
MODELLS: G-DRINK SVE GF6 / GF9 – DR6 / DR9
Page 29 of 42
AGE CONTROL
NOTE: ADDITIONAL HARDWARE IS REQUIRED TO READ IDENTITY CARD)
This function is used to permit sales from some selection only to authorized person
(after age discrimination or use of special validation card, depending of the hardware
used); this validation can be enabled only on some periods of the week.
The programming function are:
-
“ENB X ” Used to enable (X = 1) or disable (X = 0) Age control.
-
“START” Start date and time of Age control request.
-
“DAY”
Select the days of the week to start function, press enter to cycle through
the days, press enter to change the status of the day (0 = not selected, 1 =
selected). Pressing Enter it is possible to select a day. In addition to the
days (abbreviated in English) there is a submenu “ALL” that selects and
changes all the days of the week
-
“HOUR” Press enter to change the start hour and minute for selected day.
-
“STOP” Set the end date and time of Age control request
-
“DAY”
Select the days of the week for stop function, press enter to cycle through
the days, press enter to change the status of the day (0 =not selected, 1=
selected), pressing Enter again it is possible to select a day. In addition to
the days (abbreviated in English) there is a submenu “ALL” that selects and
changes all the days of the week.
-
“HOUR” Press Enter to change the stop hour and minute for selected day.
-
“TRAY X” Choose the tray on the Master to be controlled, pressing enter:
-
“ALL”
To assign all selections of this tray (OFF = not assigned, ON = assigned)
-
“CO XY” To assign single selections (OFF=not selected, ON=selected)
-
“TRAY S X” Choose the tray of the Slave (If avail) to be controlled, pressing enter:
-
“ALL”
To program all selections of this tray (OFF=not selected, ON=selected)
-
“CO XY” To program single selections (OFF=not selected, ON=selected)
-
"AGE"
Allows to set level of age (Used only in the MDB age control)
Age16: 16years old Age18: 18years old
RETURN TO OPEN DOOR MODE
If the ENTER button is activated at the "RTN" prompt the VMC will exit to normal open
door routine.