Vemer Mithos GSM RF, User Manual

Page: 47 / 60

English
- 45 -
Mithos GSM RF Chronothermostat User Manual
MANAGING THE ALARMS
The chronothermostat can be configured to sent alarm text messages to the
numbers in the telephone book.
There are four alarm sources:
– minimum alarm if the measured temperature goes below a specified threshold
– maximum alarm if the measured temperature exceeds a specified threshold
– power supply alarm if there is a blackout
– external alarm in the case of a generic alarm on the digital input
For each alarm source, it is possible to specify the numbers in the telephone book
to which the text message should be sent.
The device is configured in the factory to send alarms to the first number
in the telephone book in the following cases:
– power supply failure and restoration
– temperature measured by the internal probe below 5 °C
– alarm on closed digital input status (with 10 seconds delay)
The following commands can be used to change this configuration.
Defining alarm recipients
It is possible to specify message recipients for each alarm source.
The command syntax is:
INVIO ALLARME MINIMA [recipient] …[recipient]
INVIO ALLARME MASSIMA
[recipient] …[recipient]
INVIO ALLARME ESTERNO [recipient] …[recipient]
INVIO ALLARME ALIMENTAZIONE [recipient] …[recipient]
where:
[recipient] indicates the number in the telephone book to which the alarm is sent
Some examples:
INVIO ALLARME ESTERNO 1 3 4 sends a text message to numbers 1, 3, 4 in the
telephone book if there is a digital input alarm
INVIO ALLARME MASSIMA 2 sends a text message to number 2 in the telephone
book in the case of a temperature threshold
exceeded alarm