English
- 40 -
User Manual – Thermoregulator FHT
8) Analog output
(indicated by label
[ANG]
): type of analog output
9) Advanced
(indicated by label
[ADD]
): dependency, type, insertion,
differential/logic
All the parameters within the nine menus and their corresponding values, are listed
in the following section.
- To scan the nine menus in sequence use the
“up”
(
▲
) key
- To enter the selected menu press the
“OK”
key
-
Confi gurable parameter labels
can be scanned within each menu by pressing
the
“up”
(
▲
) key; to view a parameter value press
“OK”
(to view parameter label
again press the
“OK”
key one more time).
- To change the
parameter value
, hold the
“OK”
key pressed for at least three
seconds.
- The parameter value will begin fl ashing: increase/decrease using the
“up”
(
▲
) and
“down”
(
▼
) keys respectively.
- To confi rm the change press
“OK”
.
The parameter will stop fl ashing and the new value will be displayed
- It is possible to return to normal operation at any time by pressing the
“down”
(
▼
)
key (or not pressing any key for at least 40 seconds)
Note: if when confi guring parameters no key is pressed within 40 seconds
, the parameter label will be displayed again and none of the changes
entered will be saved.
Note: During the display and change of parameters the device will continue
operating with the previous settings.
If “password 2” has been enabled (access password for the protection of
settings -
see system menu
), the display will read
“- - - ”
when the
“up”
(
▲
) and
“down”
(
▼
) keys are simultaneously pressed for three seconds from
normal status.To proceed with parameter confi guration, enter the password
previously set (a numeric value from 0 to 255) using the
“up”
(
▲
) and
“down”
(
▼
) keys and press
“OK”
to confi rm.
If the password is correct the fi rst menu label will appear, otherwise normal status
will return.
PARAMETER MENU
To simplify device programming, parameters have been classifi ed into the following
various menus:
— [REG]
regulatation menu
— [OUT]
output menu
