VEMCO - VR2AR / VR2AR-X Manual
15 March 2019
32
5.1.3
Install Battery
With the case open, you can install the new battery. If there is a used battery in the receiver, use the
instructions found in Section 5.1.2 to remove the battery before inserting the new one. Some VR2AR
receivers are shipped with the battery inside the receiver but not connected. If this is the case for your
receiver, then move to Step 2 in the instructions below to power your VR2AR.
Slide the wireless end of the Lithium D-cell battery against the foam pad closest to the flat end of the
receiver and inside the battery compartment (see arrow in photo below and left, VR2AR model shown).
Press the wired end of the battery down into the battery compartment.
STEP 1
Position the receiver so you can see the
Status Light.
Connect the two battery connector
halves together until a “click” is heard
and the VR2AR receiver
’s light begins
flashing. Watch for a long green light to
indicate the self-tests were successful.
If you see the long red light followed by
more flashes, then contact VEMCO for
instructions.
STEP 2
NOTE
: If the VR2AR was in Recording mode (i.e. as Study had been initialized; see section 3.9) when the
battery was disconnected, then it will immediately return to recording detections after the battery has been
replaced. Settings are not lost when the power is disconnected.
