VEMAG ROBOT HP7C, Operating Instructions Manual, Page: 57 / 94

7. Maintenance
7-1
ROBOT HP7C / HP10C / HP15C / HP17C
© VEMAG 2004
7. Maintenance
7.1 General information
Apart from daily cleaning, the filler needs very little maintenance. For your
peace of mind, we recommend that you take out a service contract
whereby VEMAG Customer Service carries out all the maintenance work
due.
The information below describes the maintenance work to be performed
by the owner of the machine. The types and quantities of lubricants
required are listed in the appendix. Notes on spare parts required can be
found in the spare parts catalogue.
Section 9 and spare parts catalogue
Danger!
To prevent injury, switch off the machine before any maintenance work.
Then switch off the main switch to disconnect the machine from the
mains. The machine has to be switched on for the feed unit drive to be
lubricated.
The relevant cover of the machine housing has to be removed to allow
internal components of the drive system to be serviced.
• Undo the appropriate assembly screws with a screwdriver.
• Remove housing cover
• Carry out the necessary maintenance work according to the
maintenance schedule.
Section 7.4
• Clean the contact surfaces of the cover seals and lubricate lightly
before re-fitting.
• Put housing cover back on.
Regularly check the hydraulic system of the machine, including all pipe
and hose lines, for damage or leaks. Inform VEMAG Customer Service if
you find damage or leaks.
Warning!
DIN 20066 states that the service life of hose lines should not exceed six
years. For this reason, you should have the hose lines of the hydraulic
system checked by VEMAG Customer Service after six years to avoid
leaks.
Warning!
Used oil and other substances should be disposed of in accordance with
the relevant environmental protection regulations in force.