2-2 Pair with Your Speed and Cadence Sensor
1.
In standby mode, press to point to
PAIRING SENSOR
, press to enter.
2.
Press to point to
PAIRING BIKE
, press to create Bluetooth connection and start pairing.
3.
Paired successfully, message
OK
prompts, press to exit. Pairing failed, message
NO-DEV
prompts, press to exit to
PAIRING BIKE
and starts
from STEP 2 again.
Please refer to the Speed and Cadence Sensor manual to install the sensor and its included magnet to your bike, turn the crank counterclockwise until the sensor is connected to the
Cycling Computer and the "
OK
" message prompts.
Make sure
SPD/CAD
is set to
ON
in the Sensor Setup window. (Page 15)
Activate your Speed and Cadence Sensor before pairing by cranking to start the sensor and establish connection. Your Speed and Cadence Sensor remains awake for one
minute. It goes back to sleep mode again if no Bluetooth connection is enabled.
Keep your Speed and Cadence Sensor and Cycling Computer close to each other and away from other Bluetooth devices for correct pairing.
