VWS2E
- 4 -
VELLEMAN
Before changing the properties, write down the original network settings so you can recover them afterwards.
Click on “Use the following IP address”, set the IP address and subnet mask. The IP address should be
192.168.1.XXX, with XXX from 1 to 256 except 10 (192.168.1.XXX is the video web server default IP). The subnet
mask must always be set on 255.255.255.0.
2.
After the IP setting, connect the
VWS2E
to a PC or notebook with a crossover LAN cable. In some cases, you
might need the standard CAT5 cable.
3.
To configure the server IP, click the “Video Server E” icon twice and enter the setup.
4.
Enter the user name, password and the server IP (default user name and password are “admin”; default server IP
is 192.168.1.10, port 80). Click the green button to connect.
5.
When you are successfully logged in the
programme, following screen will appear. Click the
“System Config” button to set up.
6.
Set the baud rate, the ID and the model which you
would like to control remotely. Press “Apply” to
confirm and to enable the setting. The baud rate
setting and the ID of both devices should be identical.
7.
Next, click on “Network”, set the server IP, the gateway and net mask which
are provided from your local ISP, the web server, stream port and IP type.
Press “Apply” to confirm and to enable the settings.
Static IP