PROMIXCD4 GB
2
CAUTION
Switch off the power to each component before connecting this device with or disconnecting it from an audio system.
Make the right connections :observe the L (left channel) and R (right channel) marks. Connect the cable in a secure
manner. Loose connections will result in unsatisfactory sound reproduction and are likely to cause noise problems.
6. Case
Maintenance
Use only a damp cloth to wipe the case clean. Do not use solvents or abrasives.
7. Replacing the Crossfader Module
The crossfader will probably need to be replaced after some time as it is very heavily used. This is quite normal.
Switch off the power and disconnect the device from the mains.
Undo the top screws with a screwdriver. Lift the crossfader module clear of the device while avoiding damage to the
internal wiring.
Unplug the cable loom from the bottom of the module. Handle only the white connector block and do not pull the
cable itself. Insert the new crossfader module and replace the screws.
8. Front Panel Description
1. Speaker connections
Connect the device to your main stereo speakers with the supplied 6.3mm
jack
2. Amp output
Connect the Amp output’s RCA sockets to a power amp or similar
installation using good quality cables (not supplied)
2. Rec output
To record your mixes connect the REC OUT RCA sockets to the input of
your tape recorder or similar device.
3. Headphone socket
This socket accepts a standard ¼” (6.3mm) stereo jack.
4. Aux inputs
Use these inputs to connect your cassette deck, tuner or other line level
sources (NOT a CD player)