MML10 version 2 GB
9
Press or to view the next or previous message. For example, if the display shows message
1, you should press to view message 2. If the display shows message 1, press to view
message 4.
Press "
OFF/END
" to deactivate the display. Press "
DISPLAY/PREVIEW
" to reactivate the
display. Message 1 will start to scroll across the display again.
11. Special Features
a) Using the Alarm Message
Use the procedure outlined below if the message board is to display an alarm message when
your alarm system is triggered :
•
Connect the message board to your alarm system (read "
4. Connecting the Device to an
Alarm system
" on p. 3).
•
Connect the message board to an AC power source.
•
Activate the message board.
Note :
The alarm message will continuously scroll across the display if your alarm system has
been triggered, regardless of whether or not the display is "ON".
b) Changing the Alarm Message
Message 5 is reserved for the alarm message. Use the procedure outlined under heading "
8.
Entering a Message
" on p. 5 in order to enter an alarm message, but press
5
for the message
number.
Follow the procedure outlined under heading "
9. Editing a Stored Message
" on p. 7 in order to
edit the alarm message, but press
5
for the message number. The message "
EDIT ALARM
MESSAGE
" is displayed. Consequently, the current alarm message will appear.
c) Deactivating the Alarm Message
If the alarm system is triggered and the alarm message appears, you should put the "
ON/OFF
"
slide switch in the "
OFF
" position in order to cancel the alarm message display.
12. Using the Sequential Display
The message board can be programmed to repeat a sequence of two or more messages. The
sequence can contain up to eight message numbers but only messages 1 through 4 can be
included in the sequence. For example, you can enter the following sequence : 2, 4, 3, 1, 4, 2,
3, 1. The manufacturer’s sequence is 1, 2, 3, 4.
Altering the Sequence
Follow the procedure outlined under headings "
8. Entering a Message
" and "
9. Editing a
Stored Message
" to change the sequence, but press
6
for the message number. The display