MML10 version 2 GB
2
Mounting the Message Board on a Wall
1. Use a screwdriver to remove the screws at the back.
2. Drill two holes of approximately 1/16" (1,6mm). The two holes should be 5 7/8" (150mm)
apart.
3. Insert the supplied screws in the holes and let them protrude from the wall by ¼" (5 to 6mm).
4. Fit the keyhole slots of the back plate over the screws and press the back plate against the
wall. Tighten the screws.
5. Attach the message board to the back plate and replace the washers and screws as shown
below.
6. Adjust the viewing angle and tighten the screws.
FIG. 2
FIG. 3
FIG. 4