CAMCOLD4_v2
VELLEMAN
11
Preset setup
Select a preset which you can create or modify. If the current preset number was
predefined, the camera will move to the stored position and automatically zoom. In the
other case, UNDEFINED will be displayed. The DWELL TIME will be displayed in an
hh:mm:ss format.
Edit relay out
Define the relay output. If an output relay is activated (ON), the number corresponding to
each point will appear. You can set relay outputs per preset.
Edit present label
Edit a name for each preset. The label can be up to 15 characters long and will be
automatically displayed in the upper left corner of the screen. Use the joystick (up, down,
left or right) to move the cursor to the appropriate character. Delete a previous character
using the
←
symbol. Press OK when the name is complete and press F- to confirm.
Move the cursor to CANCEL and press F+ to abort the modification.
Edit a preset scene
Use the joystick and move the camera to desired position. Press F- to save the current
PTZ data. Press F+ to cancel the PTZ data.
Pattern setup
Select the pattern number to edit. If the pattern number does not exist, UNDEFINED will
be displayed. You can record a pattern under PROGRAM PATTERN.
Record pattern
Use the joystick and the camera to the starting position and the desired zoom. To start
recording the pattern, press F-. To exit the menu, press F+. The recorded data will be
lost. Maximum recording time is 1 minute. The remaining recording time will be displayed
in a percentage.
Swing setup
Select the swing number which you desire to create or modify. If the current swing number is not defined,
UNDEFINED SWING will be mentioned. Define the two preset positions for the swing motion. UNDEFINED PRESET
means you have assigned an undefined value for one of the positions. The SWING
SPEED can also be set. Refer to the table below.
FAST 60°/s
NORMAL 30°/s
SLOW 15°/s
The LOOP represents the number of swing motions effectuated by the camera within a group.
Summary of Contents for CAMCOLD4
Page 2: ......
