Appendix C — Filter Manager Error/Status Codes
119
Filter Manager Error/Status Codes
-73
Attempted to cue or Start an audio component
that is currently encoding.
The application may have
hung up during the previous
encode. Try calling Reset.
If that fails, restart the
application.
-74
Attempted to Pause the audio component when
it was already paused.
State problem? May need to
restart the application.
-75
Attempted to Start the audio component before
cueing it.
State problem? May need to
restart the application.
-76
Attempted to Stop or Pause the audio compo-
nent although it is not playing.
State problem? May need to
restart the application.
-77
Attempted to Resume the audio component,
although it is not paused.
State problem? May need to
restart the application.
-78
Encode failed because audio pin over- flowed, or
application was not successful in creating, ini-
tializing, or resetting the pin from the audio com-
ponent to the mux.
If error occurred when appli-
cation was coming up, check
the C drive to be sure it has
adequate swap space. If
error occurred during an
encode, the audio pin backed
up-this is usually a second-
ary error. The audio backup
is caused because some
other component failed or
“hung up” the encoder. Shut
down application, terminat-
ing CVProServer and Mem-
MgrServer if needed.
-79
A stop was issued to the audio component, but it
won't stop in a reasonable amount of time.
It may be hung up in a
while-loop. May need to
terminate application with
task manager.
-80
Software failed trying to read the firmware revi-
sion OR exception was thrown during the audio
component initialization process.
Check audio encoder hard-
ware. Make sure board is
installed properly.
Filter Manager Error/Status Codes (Continued)
Error Code
Meaning
Comments
Table C-1. Filter Manager Error/Status Codes (Continued)