Standard Installation
GPS Fleet Tracking
INSTALLATION GUIDE
Getting Started
Kit Contents:
• Tracking device (with internal antenna & attached wiring harness)
Tools Required for Installation:
• #10 x 3/4” self-tapping screws (exterior installs only)
• Power drill
• Voltmeter or test light
• Wire stripper/cutter/crimper
• Terminal/connectors
Connect RED Wire/POWER and Connect BLACK
Wire/GROUND:
• Locate a fused, constant 12 VDC power source and a suitable
chassis ground.
• Connect RED wire on harness to POWER source.
• Connect BLACK wire on harness to chassis GROUND.
Connect WHITE Ignition Sense Wire:
The ignition sense wire enables tracking of ignition ON and OFF events.
To install, locate the vehicle ignition wire by consulting the appropriate
wiring diagrams. Connect WHITE ignition sense wire to the vehicle’s
ignition source.
BEWARE! Do NOT source to a 12V accessory wire –
you must connect to the ignition wire in the FUSE BOX.
The vehicle ignition wire can be verified by measuring the vehicle’s
operating voltage while the engine is running. The vehicle’s ignition wire
should read 0VDC when the key is in the OFF position and typically
between 11V and 14V when the engine is running
©2012 Spireon, Inc. l 2012-FLVP-IG1002
WIRING DESCRIPTION:
RED
12/24 VDC Constant Power
BLACK
Chassis Ground
WHITE
Ignition (biased low)
BLUE
Input 1 (biased high)
YELLOW
Not Used
BROWN
Not Used
GREEN
Not Used
ORANGE
Not Used
