Vega Light Control Systems
● Holland, Michigan 49424
SIDE BRACKET MOUNTING
Recommended Fixtures:
•
Shoebox
•
Pendant
•
Colonial
Standard Side Brackets shown.
Other configurations available.
2.2. STEP 2: Fitting of LED Retrofit Kit into Fixture
•
Review the various mounting configurations on the following pages and select the most applicable model
•
Select and install appropriate mounting accessories if needed
•
Based on the fixture type, configure power supply assembly, brackets, and height (see 1.4.2-5)
Notes:
•
Center Pole Mounting height can be adjusted using the included hex key to loosen set screw and slide LED to
needed position. Be sure to also pull or push LED cable into position while adjusting height. After adjusting height,
tighten set screw enough to hold tube, then tighten another ½ turn with hex key. (see 1.4.2-4)
•
Side brackets can be adjusted, bent, trimmed, or special ordered to span or offset LED mounting height.
•
Allow adequate space around all sides of LED Light Engine from fixture or globe. (see 1.4.5)
•
Order a lower wattage of kit if install is still exceeding Tc limits with LED kit properly positioned.
•
Assembled Retrofit Kit may be special ordered configured ready to drop into light fixture. These options include:
o
Size and position of mounting plate and or custom mounting plates
o
Height of Light Engine set to specified height
o
Accessory Brackets attached
•
Contact Matech with any mounting questions or concerns.
Height
Adjustable
From 15”
Down
To 9.75”
CENTER POLE MOUNTING
Recommended Fixtures:
•
Post Top
Height
Adjustable
From 11”
Down
To 9.75”
Socket Replacement
Height Made to Order
Mounting Plates
available for most fitters
