VEC-821K Instruction Manual
Super CW Filter Kit
15
against the board. Solder in place and trim the leads.
37. Locate resistor R17. This is 2.7 ohm resistor (red-violet-gold).
Carefully bend the leads close to the resistor body as in Step
#1.
38. Insert R17 into its mounting holes so the resistor body rests
against the board. Solder in place and trim the leads.
39. Locate resistor R19. This is 5.6 ohm resistor (green-blue-gold).
Carefully bend the leads close to the resistor body as in Step
#1.
40. Insert R19 into its mounting holes so the resistor body rests
against the board. Solder in place and trim the leads.
Now that you have finished Phase 1, you may want to take a few minutes
to double check your work. There are two additional phases to go and
quite a few additional parts to be installed; making the board more
crowded and hard to find the different components.
Now that you have finished your double check it is time to move on.
Phase 2:
Important Note:
Capacitors C12-C19 are made of a polystyrene type material.
Avoid overheating these components when soldering to prevent melting the
capacitor body.
1. Locate capacitor C12 (1000pF). The is a polystyrene capacitor
and will be marked with a "1000J" on the body. (actual value in
pF).
2. Mount C12 and solder both leads in place, making sure the
capacitor remains seated. Remove excess leads on the bottom
side of the board with diagonal cutters.
3. Locate capacitor C13 (1000pF). The is a polystyrene capacitor
and will be marked with a "1000J" on the body. (actual value in
pF).
4. Mount C13 and solder both leads in place, making sure the
capacitor remains seated. Remove excess leads on the bottom
side of the board with diagonal cutters.
5. Locate capacitor C14 (1000pF). The is a polystyrene capacitor
and will be marked with a "1000J" on the body. (actual value in
pF).
6. Mount C14 and solder both leads in place, making sure the
capacitor remains seated. Remove excess leads on the bottom
side of the board with diagonal cutters.
7. Locate capacitor C15 (1000pF). The is a polystyrene capacitor
and will be marked with a "1000J" on the body. (actual value in
pF).
8. Mount C15 and solder both leads in place, making sure the
