TCY-FT-U
Technical Specifications
Doc: 70-00-0128B, V1.2, 20110621
© Vector Controls GmbH, Switzerland
Page 3
Subject to alteration
Connection diagram
Description:
G0
0V
Power supply:
0VAC, internally connected to signal common
G
24V
Power supply:
24VAC
M
0V
Signal common:
Common 0 potential for analog inputs and analog outputs.
X1
RT
External temperature input:
NTC 10k
Ω
@ 25°C (77°F)
TCY-FT2-U:
X2
CO
Change over input:
NTC 10k
Ω
@ 25°C (77°F)
Y1
DO1
Binary output:
Valve open
Y2
DO2
Binary output:
Valve close
TCY-FT4-U:
Y1
DO1
Binary output:
Heating valve open
Y2
DO2
Binary output:
Heating valve close
Y3
DO3
Binary output:
Cooling valve open
Y4
DO4
Binary output:
Cooling valve close
Mechanical Design and installation
The unit consists of two parts: (a) The power case with attached mounting plate and (b) the front part.
Mounting location
•
On an easy accessible interior wall, approx. 1.5 m (4.5’) above the floor in an area of average temperature.
•
Avoid exposure to direct sunlight or other heat sources, e.g. the area above radiators and heat emitting electrical
equipment.
•
Avoid locations behind doors, outside walls and below or above air discharge grills and diffusers.
•
Location of mounting is less critical if external temperature sensors are used
Installation
1.
Connect the wires to be connected to the terminals of the power case according to wiring diagram
2.
Install the mounting plate to the flush mounting box. Make sure that the nipple with the front holding screw is
facing to the ground. Make sure the mounting screw heads do not stand out more than 5 mm (0.2”) off the
surface of the mounting plate.
3.
Ensure that the jumpers are set correctly.
4.
Slide the two latches located on the top of the front part into the hooks at the upper side of the mounting plate.
5.
Carefully lower the front part until the interconnector reaches the mounting-plate. Continue pressing in a gentle
way until the front part is fully connected. While inserting the connectors, a slight resistance can be felt. This is
normal. Do not use excessive force!
6.
With a Philips-type screw driver of size #2, carefully tighten the front holding screw to secure the front part to
the mounting plate. This screw is located on the front lower side of the unit. There is no need to tighten the
screw too much
X
T INT
0V (COM)
24V AC/DC
2
G
TCY-FT4-U
1
G0
3
Y1
Heat
OPEN
4
Y2
Heat
CLOSE
7
M
Signal
COM
8
X1
X
T EXT
IN
5
Y3
Cool
OPEN
6
Y4
Cool
CLOSE
X
T INT
0V (COM)
24V AC/DC
2
G
TCY-FT2-U
1
G0
3
Y1
OPEN
4
Y2
CLOSE
X
T CO
IN
6
X2
COM
5
M
8
X1
X
T EXT
IN
7
M
COM
