background image

2

SAFETY GUIDELINES / DEFINITIONS

DANGER:

Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.

WARNING:

Indicates a potentially hazardous situation which, if not  avoided, could result in death or serious injury.

CAUTION: 

Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.

CAUTION:

Used without the safety alert symbol indicates potentially hazardous situation which, if not avoided, may result in

property damage.

RISK OF UNSAFE OPERATION.

When using tools or equipment, basic safety precautions should always be followed to

reduce the risk of personal injury. Improper operation, maintenance or modification of tools or equipment could result in
serious injury and property damage. There are certain applications for which tools and equipment are designed. Black &
Decker strongly recommends that this product NOT be modified and/or used for any application other than for which it
was designed. Read and understand all warnings and operating instructions before using any tool or equipment.

IMPORTANT SAFETY INSTRUCTIONS

WARNING:

This product or its power cord contains lead, a chemical known to the State of California to

cause cancer and birth defect or other reproductive harm. Wash hands after handling.

WARNING: BURST HAZARD: 

Do not use the unit for charging dry-cell batteries that are commonly used

with home appliances. These batteries may burst and cause injury to persons and damage property. Use the
unit for charging/boosting a LEAD-ACID battery only. It is not intended to supply power to a low-voltage
electrical system other than in a starter-motor application.

WARNING: SHOCK HAZARD:

• If an extension cord is used, make sure that:

a) the pins of extension cord are the same number, size and shape as those in the charger,
b) the extension cord is properly wired and in good electrical condition,
c) the wire size is large enough for the AC rating of the charger as indicated in the table on page 2.

• Do not operate unit with damaged cord or plug; or if the unit has received a sharp blow, been dropped, or

otherwise damaged in any way. Do not disassemble the unit; take it to a qualified service technician when
service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire, and will void
warranty.

• Use of an attachment not supplied, recommended or sold by manufacturer specifically for use with this unit

may result in a risk of electrical shock and injury to persons.

• NEVER submerge this unit in water; do not expose it to rain, snow or use when wet.
• To reduce risk of electric shock, disconnect the unit from any power source before attempting maintenance or

cleaning. Turning off controls without disconnecting will not reduce this risk.

WARNING: RISK OF EXPLOSIVE GASES

• Working in the vicinity of a lead acid battery is dangerous. Batteries generate explosive gases during normal

battery operation. For this reason, it is of the utmost importance that each time before using the jump-starter
you read this manual and follow instructions exactly.

• To reduce the risk of battery explosion, follow these instructions and those published by the battery

manufacturer and manufacturer of any equipment you intend to use in the vicinity of the battery. Review
cautionary markings on these products and on the engine.

Minimum Gauge for Cord Sets

Volts 

Total Length of Cord in Feet

120V

0-25

26-50

51-100

101-150

(0-7,6m)

(7,6-15,2m)

(15,2-30,4m)

(30,4-45,7m)

240V

0-50

51-100

101-200

201-300

(0-15,2m) (15,2-30,4m)

(30,4-60,9m)

(60,9-91,4m)

Ampere Rating

More

Not more

American Wire Gage

Than

Than

0   -

6

18

16

16

14

6      -

10

18

16

14

12

10  -

12

16

16

14

12

12 -

16

14

12

Not Recommended

90527010 VEC012 EN SP.qxp:VEC012_ManualEN_090407  9/11/09  8:17 AM  Page 2

Summary of Contents for START-IT 450 AMP JUMP-START SYSTEM


















Reviews: