Vector e-bike, Manual

Page: 38 / 46

Wheels and tires
Proper tire maintenance is very important. Check that there are no cuts, cracks, rips, lumps or bumps
on the body of the tire before each use.
IF YOU NOTICE ANY ABNORMALITY IN ANY OF THE TiRES REPLACE IT IMMEDIATELY.
Check and adjust the tire pressure with each use of the vehicle. Always do this when the tires are cold,
which means that they have not been used in the hours prior to checking them.
Please check wheel misalignment. Remember they have to be always aligned with the chassis to
avoid driving problems.
INADEQUATE PRESSURE OR POOR TYRE CONDITION CAN CAUSE:
- Unexpected bursts.
- Loss of vehicle control.
- Reduction of efficiency in the case of too low pressure.
Respect the minimum depth of the profile and if it is less, change the tire.
Make sure that the spoke tension is correct since that can cause unstable behavior.
Check that all spokes are tight.
In the event of any spoke is not tight enough, go to your Vector Official Dealer or Service.
SUGGESTED PRESSURE:
1,8 BAR front – 2,2 BAR rear
MINIMUM PROFILE DEPTH:
≥ 2 MM