7
Common Power Output Problems
Possible Causes
Recommendations
Battery voltage
Recharge battery or check
below 10.7 volts
DC power supply.
Equipment being operated
Reduce load to maximum 100 watts.
draws too much power
Inverter in thermal
Allow inverter to cool down. Ensure
shutdown condition
there is adequate ventilation around
the unit, and the load is no more
than 100 watts for continuous operation.
AC output is shorted
Disconnect the AC appliance. Press the
inverter ON/OFF Power pushbutton to
turn the unit OFF. Wait a few seconds,
then press the pushbutton again to turn it
back ON.
SPECIFICATIONS
Output Power:
100 watts continuous
Output Voltage (RMS):
115 volts AC ±10%
Output Frequency:
60Hz ±3Hz
Output Waveform:
Modified Sine Wave (MSW)
DC Input :
13.8VDC, 8 Amps
Efficiency:
>85%
Low Voltage Audible Alarm:
<11 Volts Input Voltage
Low Voltage Shutdown:
<10.7 Volts Input Voltage
Operating/Storage Temperature: 0-40°C (32-104°F)
Operating/Relative Humidity:
5-95% non-condensing
6
CARE AND MAINTENANCE
Storage
1. Ideal storage temperature range is 0-40°C (32-104°F).
2. Store and use the
100 Watt Slim Power Inverter
in a cool, dry place with
adequate ventilation for all-around air circulation.
3. Avoid locations that are exposed to heating units, radiators, direct sunlight, or
excessive humidity or dampness.
Fuse Replacement (12 Volt DC Accessory Cord)
1. Unscrew the cap of the barrel end of the 12 Volt DC Cord (turning counter-
clockwise) and lift off.
2. Pull the fuse straight out.
3. Replace with a new 10 amp fuse.
4. Screw the cap back onto the plug (turning clockwise).
TROUBLESHOOTING
Common Audio/Visual Problems
Problem: Buzzing Sound in Audio Systems
Some inexpensive stereo systems and boom boxes make a buzzing sound when
operated from the inverter, because the power supply in the electronic device does
not properly filter the modified sine wave produced by the inverter. The only solution
to this problem is to use a sound system that has a higher quality power supply.
Problem: Television Interference
The
100 Watt Slim Power Inverter
is shielded to minimize interference with TV
signals. However, in some instances, some interference may still be visible, especially
when the TV signal is weak. Try the following to improve the picture:
1. Move the 100 Watt Inverter as far away as possible from the TV set, the antenna,
and the antenna cables. Use a short AC extension cord, if necessary.
2. Adjust the orientation of the antenna cables, and the TV power cord to minimize
interference.
3. Make sure that the antenna feeding the TV provides an adequate (snow-free)
signal and that high quality, shielded antenna cable is used.
Fault LED Lights/Alert Buzzer Sounds
When the Power/Fault LED turns from blue (indicating the unit is powered) to red and
the alert buzzer sounds, a fault condition is present and the unit will automatically shut
down shortly. See “Protective Features” on page 5 and “Common Power Output
Problems” below.
VEC415_Manual_NP_032806 4/18/06 12:21 PM Page 6
