background image

5

WARNINGS:

DO NOT ALLOW BARE WIRES OR CONNECTORS TO CONTACT
EACH OTHER DANGEROUS SPARKING CAN OCCUR - NOTE
WHICH WIRES ARE ON THE BATTERY TERMINALS

6. Note polarity of battery. Note which wire is on which terminal.
7. Disconnect the wires from the battery and set the battery aside.
8. Connect the replacement battery, making sure the correct wires are on the new 

battery terminals. Make sure POS (+) is red and NEG (-) is black.

CAUTION:

Incorrectly connected wires will not allow the spotlight to operate or
recharge. Incorrect battery polarity will damage the circuits inside the
spotlight. Double check battery polarity before reassembly!

9. Replace battery compartment end cap. Make sure wires are not crushed. 
10. Replace four Phillips screws in battery compartment cover. Do not over tighten.
The lower battery pack can be replaced by following the upper battery replacement
procedure except there are only two Phillips screws to be removed. 
After the lower battery is replaced and the lower end cap secured, recharge for 10-12
hours using the AC Recharge Adapter before using the spotlight.

SAFE BATTERY DISPOSAL

Contains a maintenance-free, sealed, non-spillable, lead acid
batteries, which must be disposed of properly. Recycling is
required, contact your local authority for information. Failure to
comply with local, state and federal regulations can result in fines,
or imprisonment.

Battery Disposal Warnings:

• Do not dispose of a battery in fire as this may result in an Explosion.
• Before disposing of the battery, protect exposed terminals with heavy-duty electrical

tape to prevent shorting (shorting can result in injury or fire).

• Do not expose batteries to fire or intense heat as they may explode.
• For more information on recycling these batteries, call toll-free 877-288-7722.

7. SPECIFICATIONS

Spotlight Bulb  . . . . . . . . . . . . . . . . .12 volt, H3 series Vector Part No. VEC190
Battery  . . . . . . . . . . . . . . . . . . . . . . . .Two maintenance free, sealed lead acid, 

6 volt, 6.0 Amp Hour Vector Part 
No. VEC191 

Weight  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .((( PLEASE WEIGH))))
Length  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Width  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Height  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Summary of Contents for 3












Reviews: