2
5. CHARGING AND POWERING THE VECTORLITE
USING THE DC RECHARGE ADAPTER
The VEC120 can be simultaneously charged and operated from a12 volt DC source.
Make sure the 12 volt source can supply at ;least 15 amperes of current if the spotlight
is to be operated while the batteries are being charged.
To check the battery level, press the Battery Status Pushbutton (Figure 2). Charge until
Battery Status Display?s green LED lights when the Battery Status Display Pushbutton is
pressed. Charge after each use. See Figure3B DC/DC Recharge Adapter.
1. Locate the DC Recharge Port on the rear of the spotlight (see Figure 2).
2. Connect the DC charger to a 12 volt DC source that can supply at least 15 amps
of current.
3. Plug the DC charger’s polarized connecter into the DC Recharge Port.
4. Recharge for 10-12 hours maximum or until the green LED lights when the battery
Status Display Pushbutton is pressed.
5. After recharge, disconnect the Adapter from the external charging/power source
then disconnect the connector from the DC Recharge Port.
Note that some vehicles must have the ignition switch on to power the vehicles acces-
sory outlet.
WARNING:
NEVER SIMULTANEOUSLY CONNECT AC/DC AND DC/DC
CHARGERS TO SPOTLIGHT.
6. PERIODIC MAINTENANCE
All batteries lose charge over time, especially when they are warm. AC recharge is
recommended every two months, when not in frequent use. Use the AC/DC Recharge
Adapter and charge for the recommended time. If the unit has dirt on it, gently clean
the outer surfaces of the spotlight unit with a soft cloth moistened with a mild solution of
water and detergent. Periodically inspect the condition of recharge adapters, connec-
tors, and wires. Replace any components that may have become worn or broken.
7. PARTS REPLACEMENT
Several parts are replaceable by users. The quartz halogen bulb and two sealed lead
acid batteries are available through Vector Manufacturing. A substitute 12 volt H3 55
watt bulb may be used instead of a Vector bulb. These can also be purchased from
popular automotive parts suppliers nationwide. Vector Manufacturing’s Technical
Support Department for replacement parts and any additional information that you may
need. They may be reached at (954) 584-4446 or toll free at (866) 584-5504.
Summary of Contents for 3
Page 4: ...6...
