3
To replace either or both H3 type 12 volt bulbs, you will need a small Phillips type
screwdriver and a replacement bulb (or bulbs) Vector Part VEC190. Bulb life can be
shortened by installing a bulb with dirt or fingerprints on it. The bulb can be wiped
clean with cloth moistened with alcohol. During bulb installation, avoid touching the
glass part of the bulb. See Figures 4, and details 4A and 4B. Note which bulb is
burned out.
1. Disconnect the unit from any charging adapters
2. Pull the rubber bezel towards the front of the spotlight to reveal two small Phillips
screws in the wide Reflector Assembly Retainer. The screws are on opposite sides of
the retainer.
3. Using the screwdriver, remove (counter-clockwise) the two screws. Set them aside.
4. Lift off the Retainer, glass lens and rubber ring and set them aside.
5. Carefully remove the dual reflector and bulb assembly. See figures 4.
6. Disconnect the bulb wire from the red power wire and set the burned out bulb aside.
7. Unsnap the hairpin retaining wires from the reflector’s flange (see details 4A and 4B)
8. Using the screwdriver, loosen the retaining screw to remove the bulb from the
reflector (no need to completely remove this screw).
9. Lift out the bulb and the attached wire.
10. Insert the replacement bulb into the reflector’s flange.
11. Put back and secure the hairpin retaining wires.
12. Connect the white bulb power wire to the red power wire.
13. Tighten the retaining screw on the flange.
Rubber
Bezel
Reflector
Assembly
Retainer
Reflector
Rubber
Ring
Lens
(Glass)
Phillips
Screws
Hairpin
Retainer Wires
Summary of Contents for 3
Page 4: ...6...
