Vectaire Heatrec1003, Installation, Operating And Maintenance Instructions

Page: 2 / 16

Page 2
"HEatREC1003" - SInglE ROOM HEat RECOvERy UnIt
InStallatIOn, OpERatIng & MaIntEnanCE InStRUCtIOnS
Safety notice
It is important to read this Instruction Manual carefully before installing or using the product. Following these instruc-
tions will ensure that your heat recovery unit is installed, commissioned and used properly and continues to operate ef-
fectively. vectaire will not be held responsible and will not accept liability for any damage caused to persons or property
through failure to follow the guidance provided in this manual. It should always be available with the product for easy
reference.
general Information
The Vectaire Heatrec1003 single room heat recovery unit can be used in any room which has an outside wall open to
fresh air. It is particularly useful in the bathroom, kitchen or utility room where high levels of moisture are generated, and
is designed to run continuously at its lower speed. It can also be used in the lounge or dining room to provide a fresh air
supply to reduce dampness, condensation and potential mould growth.
The system will operate continuously to create a stable, comfortable, healthy environment avoiding the use of excessive en-
ergy and recovering up to 75% heat already generated.
The Heatrec 1003 is available with 3 tube/heat exchanger lengths - 400mm, 500mm and 600mm lengths. It is impor-
tant that you have the correct length for the wall where it is being installed.
the system is designed to run continuously and should nOt be switched off except for maintenance or filter replacement.
It is important to follow the advice in this user manual and correctly install and maintain the system to ensure a healthy
and comfortable indoor environment.
Installation
It IS IMpORtant tHESE InStRUCtIOnS aRE REaD FUlly BEFORE InStallatIOn
• This product should not be used for any purpose other than that for which it was designed and as shown
in this leaflet.
• All packaging should be removed and the unit checked for damage in transit. If there is any damage, please contact your
supplier.
• Packing material should not be left within the reach of children or unskilled people and any hazardous parts
must be disposed of responsibly (polystyrene, plastic, polypropylene, etc.).
• In order to comply with Construction (Design & Management) Regulations, sufficient access for safe maintenance,
or removal following installation, MUSt be provided for this product.
• The unit must nOt be installed:
- where there is excessive oil or grease
- where there are hazardous gases, liquids or vapours that are flammable or corrosive
- in ambient temperatures above 40ºC
- where it could be exposed to outside elements - rain, sun, snow etc
• The product must be connected to the electricity supply via a double or triple pole isolating switch located in the
proximity ---of the fan.
• The product should only be connected to the mains electricity supply or electrical outlet if:
- your electrical voltage and frequency correspond to those shown on the rating label.
- the capacity of your electricity supply is sufficiently powerful to operate the product at its maximum power.
Installation of the appliance MUSt be carried out by a qualified and suitably competent person and should be
carried out in clean, dry conditions where dust and humidity are at minimal levels. The unit is not suitable for
installation on the exterior of the dwelling.
Handling
• Care should be taken when transporting the unit. Dropping or knocking will damage the inner workings of the unit.
• The unit should always be stored in a clean, dry environment.
• Remove all packaging before installation.
pre-inspection
• Inspect the unit and electrical supply cord for any damage (damage must be repaired by a suitably qualified and
competent person).
• Check all parts are supplied as shown on page 4.