LVP615D series user manual
Chapter 5: Basic user instructions
Note
：
5.3.1 In mosaic mode, PIP display is available.
5.3.2 In following conditions
，
LVP615D
cannot enter mosaic status.
（
1
）
The input signal selected is not DVI
；
（
2
）
Bypass is on
；
（
3
）
The resolution of DVI input signal is different from the output resolution of processor.
5.4 Other basic user operation
5.4.1 Brightness selection
（
Brt+
，
Brt-
）
LVP615D
supports 64 level or 100 level brightness selection. According to“8.5 bright level” selection
，
adjustment range has two kinds
：
0~64
or
0-100.
Factory default is
0-64
。
To make sure of full gray
scale of output image, it always set as 64
（
0-100 default value is 50
） ！
button
description
BRT-
Reduce
LVP615D
output brightness
，
the lowest is 0.
BRT+
Increase
LVP615D
output brightness, the highest is 64 or 100.
5.4.2 VGA input auto adjustment (Auto)
When LVP615D is in one key switch status and current valid input signal is VGA, press
Auto
button to
adjust VGA input signal sampling parameters. Then the VGA output image can be clear and full.
This operation is normally performed when a new VGA source is connected. Auto adjustment time is
depend on the signal status. Normally it’s less than 1 second. Sometimes it’s necessary to perform
several times until the output image is clear, full and stable.
