VDO DTCO 4.1, Instruction Manual

Page: 70 / 172

6
Operation by the contractor Inserting member state and vehicle registration number
70
Instruction manual DTCO 4.1 - Edition 02/2023 - BA00.1381.41 100 102
12:51  0km/h
 123456.7km 
Fig. 46: Standard display with inserted com-
pany card
Result: The DTCO 4.1 is ready.
• You can only download mass memory
data in order to archive and evaluate
these according to legal requirements.
è
Downloading data [
}
45]
• You can also access the data of an in-
serted driver card, e.g. to download it.
• Faults on the DTCO 4.1 or the system
components are shown in the display.
Confirm the message with the button
.
è
Meaning of messages [
}
102]
■ Inserting member state and
vehicle registration number
Country identification and registration
number are stored as standard during
the installation and calibration by the au-
thorised specialist workshop.
• If this was not the case, you will be
prompted by the DTCO 4.1 during first
insertion of the company to enter the
following vehicle data:
– Member state
– Vehicle registration number.
è Inserting member state and
vehicle registration number [
}
70]
The entries are stored in the DTCO 4.1.
IMPORTANT
Correctly entering the registration num-
ber.
You can only enter the registration
number into the DTCO 4.1 once.
Therefore, please enter the registration
number exactly as it appears on the
vehicle.
After that, a change is only possible
through an authorised specialist work-
shop using a workshop card.
 enter Vehicle
Reg. Number? Yes
Fig. 47: Prompt for entering the registration
number
1. Use the buttons / to select Yes
and confirm with button .
The request to enter the member
state is displayed: