UM0000001 Rev_0 (2019/11/25)
Page
21
of
36
Copyright 2019 Sound Technologies
5810 Van Allen Way, Carlsbad CA 92008
800.268.5354 | soundvet.com
7
SYSTEM SET-UP
If national or local legal regulations require that specialized personnel perform the SMART RLT
Sport installation, these regulations must be complied with.
7.1
Receipt and Unpacking
Unpack your laser as follows:
1.
Open the box.
2.
Remove protective packaging cover.
3.
Inspect the packaging contents.
7.2
Setup
WARNING!
DO NOT USE SYSTEM BEFORE FORMAL APPLICATIONS TRAINING BY Sound
PERSONNEL.
Laser Setup
1.
Setup Location
a.
Ensure that the surface will properly support the entire system.
b.
Place within 9 feet of an available 110 VAC/50-60Hz electrical outlet
c.
Ensure adequate airflow around the system
•
Be cautious not to block air vents on the side of the case.
•
There must be a minimum 4” clearance around the sides of the system.
2.
Open the case and verify components are placed neatly inside.
•
Uncoil the fiber optic cable and inspect hand piece.
•
Make sure that the emergency stop button is disengaged and in the up position
3.
Locate and uncoil the AC power cord.
4.
Plug the power cord into the AC input on the front side of the laser system.
5.
Plug the male end of the AC power cord into an available electrical outlet.
“Warning: To avoid risk of electrical shock, this equipment must only be connected to a supply
mains with protective earth”
6.
Refer to the Operation Section of the User Manual, located on the Tablet Desktop, to
configure and operate the system.
