VBrick Systems VB6000 Series, Getting Started Manual

Page: 49 / 86

VBrick Appliance Getting Started Guide 41
Chapter 6
Using the IR Remote
VBrick appliances support features provided through an optional hand held IR (infrared)
remote control. The IR remote enables users to access VBrick appliance functions and
control functions with simple program commands. Front Panel Edit options are model
dependent. For example, a dual encoder will allow editing of two destination IP Addresses
and ports. The IR remote control has limited functionality. If enabled, you can use the IR
remote control to set the IP address and perform certain other functions. Use the * button
for the decimal point and the Left and Right buttons to erase entries. Aim the remote at the
sensor on the front panel IR Port of the encoder. To enable or disable the IR remote, go to
Configuration: System > General > IR Enable. The remote is enabled by default.
Topics in this chapter
Front Panel Edit. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 41
MPEG-2/MPEG-4 Remote Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43
WM Remote Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48
Front Panel Edit
The Front Panel is the LCD display on the front of the unit. Certain keys (see below) on the
IR remote control can be used to set configuration parameters. Front Panel Edit can be
invoked by pressing
Local Edit
key on the remote control. The default password is
23646
(which is admin, numerically). Press the
Select
key to enter. IR remote control of Local Edit
is set in IWS under
Configuration: System > General > IR Enable
. Entering the operator
password (default =
operator
) will not allow changing the IP Address, Subnet Mask, or
Gateway IP. Entering the administrator password (default =
admin
) allows changing all of the
configurable parameters.
Table 7. Front Panel Edit Keys
Key Description
Up Terminate string from cursor
# Terminate string from cursor.
* Period (.) used in IP addresses.
Down Backspace.
Left Shift cursor to the left.
Right Shift cursor to the right.
Select Change current setting and continue to next setting.
Next Page Don't change current setting and continue to next setting.
Numbers Numbers for editing.