
Page 4 / 10
3. CUSTOM SETTINGS MODE (nighttime operation only)
●
Set motion-sensor operation to go on at a specified time, turn the wall switch “OFF” and then
turn it “ON” within 3 seconds at that time. The light will go into motion-sensor operation at the
specified time every night. The light turns off automatically at dawn.
●
For example, a homeowner wants to have the light stay on high-level brightness from dusk to
8pm. At 8pm, the homeowner would like the light to go into motion sensor mode. To achieve
this, the homeowner will, at 8pm, turn wall switch on and off within 3 seconds. This sets the light
such that every day, the light will behave the same way.
●To revert back to Default, turn the wall switch “OFF” and then turn it “ON” over 5 seconds again.
Note: You can adjust the low-level (0~50%) and high-level (50~100%) brightness by using the brightness
switch on the back plate. (See Fig. 7)
Notes:
1. The sensitivity of the motion sensor will increase as the
environmental temperature gets cooler. You may wish to
make adjustments when the season changes.
For best performance, gently clean the lens with a soft
cloth every 1 or 2 months to assure maximum sensitivity.
2. For best performance, install fixture at least 8 feet above
the ground. At such a height, the fixture will provide a
detection distance of up to 70 feet at 77 degrees
Fahrenheit. (See Fig.8)
3. The sensor detects movement across a detection range
of 240 degrees. (See Fig.9)
4. The sensor will be more sensitive to motion across its
detection path than motion directly towards it. (See Fig.10)
5. To reduce possible nuisances, do not mount the fixture
near a heat source like an air conditioner, vent or furnace
exhaust, or in a direction facing any reflecting object or
other light source.
25'
8.0'
12.0'
70'
Where you install your fixture is important:
Be sure the light is mounted straight on the wall
or eave; otherwise, the detection distance may
be limited.
Fig. 8
Fig. 9
Motion
Least sensitive
Motion
Most sensitive
Sensor
Fig. 10
160826
240'