
Page 2 / 10
Installation Steps
1. The fixture mounting bracket is pre-assembled on the light fixture. Unscrew
both the decorative cover and the fixture mounting screw in order to remove
the mounting bracket.
2. Install the mounting strap to the outlet box with the stamped word “FRONT”
facing away from the outlet box, using two mounting screws that best fit the
outlet box. Mounting bracket should sit flush against wall surface when
secured.(Choose one matching pair of suitable mounting screws from the
3 pairs provided)
3. Pull out the source wires from the outlet box.Unscrew the screws from the
terminal station. And connect the black wire from the outlet box to the “L”
interface of the terminal station on the mounting bracket. Connect the white
wire from the outlet box to the “N” interface of the terminal station on the mounting bracket. Then tighten the screws
back to screw the wires in place.
Carefully tuck the wires back into the outlet box.
4. Place mounting bracket against the outlet box, insert the mounting bracket screw through the mounting bracket hole,
thread mounting bracket screw into the center hole of the mounting strap. Tighten the mounting bracket screw securely.
▲ When mounting to a wall, the “UP” arrow must point upward. (See Fig. 1)
▲ When mounting to an eave, the “UP” arrow must point toward the building.
5. Attach the back plate of the light fixture to the mounting bracket, secure it with the fixture mounting screw.
6. Push the decorative cover firmly into the fixture mounting screw hole on the light fixture.
7. With silicone caulking compound, caulk completely around where the
mounting bracket meets the wall surface.
CAUTION: Be sure to caulk completely where the mounting bracket meets the wall surface to prevent water
from seeping into the outlet box.
Sensor
Mounting Strap
Mounting Bracket
Outlet Box
Back Plate
Mounting Screw
Light Head
sensor
Adjusting the Sensor Head:
1. Aim sensor head toward desired detection area, maintaining a
5° - 40° downward angle to allow moisture to drain.
Note: Make sure sensor head is positioned with control knob facing
towards the ground.
Turn off the power at fuse or circuit box.
Turn on the power at fuse or circuit box.
Fig. 2
Fixture Mounting
Screw
Mounting Bracket Screw
Fig. 1
FRONT
Decorative cover
160826
N
L