PAGE: 7 / 10
Transmitter
Wall Bracket
Screw
7
Note: Remote controller can not be used along with a solid-state speed control at the same time.
6
Turn OFF the electric circuit at the main fuse or circuit breaker box. (See Fig.18)
Fig.19
Receiver
Canopy
Hanger Bracket
Unscrew the canopy. Remove the wire connectors from the fan to ceiling
wire connection. The receiver should be removed from the hanger bracket.
(See Fig.19)
18
Install the battery (9V, included) into the transmitter.
* Press "HI" button to turn on the fan at high speed.
* Press "MED" button to turn the fan in medium speed.
* Press "LOW" button to turn the fan in low speed.
* Press "FAN OFF" button to turn off the fan.
* Press "REVERSE" button to set direction of fan rotation.
The fan will shift to high speed regardless of which fan speed was previously selected.
Then, the speed will slow down until the fan is turned off and it will restart by spinning in
the reverse direction and resume the previously selected speed setting.
* Press "LIGHT ON/OFF" button to turn on or turn off the light.
* Press "DIMMER" button to dim or brighten lights to the desired level and release, and the
brightness level will be memorized. Turn on the light again, then fan light will be restored
to the brightness-level at which was dimmed last time.
Note:
This remote controller has a memory function setting. The fan will operate at the same
speed and the fan light will stay at the same brightness-level as the last time the power
supply was turned off.
Set the code:
Within the 10 seconds time frame after the main power is turned on, press and hold FAN OFF
button more than 3 seconds. The LED light will begin to flash will begin to flash. Once set
code successful, the fan turned off and the light turned on.
Note: Included transmitter matched with receiver was the factory default settings, no need to
set the code again. Go through these setup steps if you found your transmitter can’t match
with receiver.
Install the transmitter wall bracket on the wall with two screws and place transmitter in it
carefully.
230209