Vaughn Hydrastone ME Series, Operation And Installation Manual

Page: 9 / 20

8
F. FILLING THE HEATER

Completely fill heater before turning on elements.

Water connections completed and free of leaks.

Check for proper installation of relief valve.

Close drain valve.

Open highest hot water faucet.

Open cold water inlet valve and fill system.
G. WIRING

TANK MUST BE FULL OF WATER BEFORE POWER IS ON.

Separate fused branch circuit (refer to local codes).

Mark the electrical shut off for future reference.

Wiring diagram (see Table I)

Aluminum conductors (see wiring instructions).

Check to see that voltage on rating plate and supply agree.

CAUTION: Unit must be properly grounded.
H. INSTALLATION COMPLETED AND CHECKLIST FILLED OUT
BY____________________________________________________
DATE: ________________________________________________
SPECIAL NOTE: Test of hot water after installation is necessary to be sure
temperature controls are working properly. (See water temperature regulation
information on page 8.)