14
PARTS LIST
1.
Top Pan
2.
Relief Valve -
Located above and to the left of hot water outlet.
3.
High Limit Safety Switch –
Manual reset switch designed to shut off all
electrical circuits if water reaches the setpoint of 170
F or greater.
4.
Automatic Thermostats
– For constant temperature control, thermostats
are specifically designed for Hydrastone
water heaters. Located under
access plates.
5.
Plastic Jacket
– Durable & easy-to-clean jacket is hi density plastic.
6.
Water Diffuser
– Introduces cold water at the bottom of the tank in a flat,
gentle swirl, preventing turbulent mixing with heated water above. Tank
drain is also a part of the cold water diffuser.
7.
Hot Water Outlet Nipple with Heat Trap
8.
Wiring & Connections
– Located in front of the heater for easy
installation and access. All wiring is designed for operation up to 6KW @
240volts.
9.
Long-Life Heating Elements
– Waste is reduced with immersed heating
elements because all available heat passes directly into the water. Low watt
density elements assure longer life – and reduce mineral buildup.
10.
High-Density Insulation
– Two inches of high-density foam blanket the
storage tank. Extra thickness on top and bottom significantly reduce heat
loss.
11.
Bottom Pan
NOTE: When ordering parts, please specify model and serial number of tank,
shown on the rating plate, as well as parts name, information and number.
Summary of Contents for Hydrastone ME Series
Page 14: ...13 INSTALLATION DIAGRAM PARTS LOCATION Figure I ...
Page 16: ...15 WIRING DIAGRAMS Table 1 ...
Page 19: ...18 NOTES ...
