Vatech PaX-Reve3D, Installation Manual

Page: 32 / 56

PaX-Reve3D
30
3.6. Balancing the equipment
Because this system deals with operation of a moving parts, this step to balance the unit before putting
into operation is mandatory to enable the system operate in a stable , smoother way leading, eventually,
to an acquisition of better quality of image.
The level is required to do this job.
1. First place the level on the front top edge of the vertical frame, as shown in the figure.
While observing the level, adjust the bolts on both right and left sides of base until it is balanced.
2. Place the level on the side top edge of the vertical frame.
While observing the level, adjust 4 bolts shown in the circles until balancing is obtained.
3. Cover those 6 holes with the supplied rubber hole caps (Accessory No.21).