Vatech PaX-i3D Smart, Installation Manual

Page: 16 / 161

Pax-i3D Smart(PHT-30LFO) Installation Manual
16
1 Introduction
1.1
Manufacturer’s Liability
As the manufacturer, VATECH assumes liability for the safe and reliable installation and operation of
this equipment only when:
● Equipment installation, including software installation, was carried out by an authorized agent in
accordance with this installation manual.
● Electrical installation was carried out in accordance with the appropriate requirements specified
in IEC-60363 .
● Genuine original or approved replacement parts are used.
● Maintenance/repair service has been performed by a qualified technician(s) from one of our
authorized agents.
● The equipment has been used under normal condition in accordance with the user's manual.
● PC Software has been properly used in accordance with the manufacturer’s installation
instructions and user manuals.
1.2
Customer’s Responsibility
Site planning and preparation are the responsibility of the customer. The following points should be
considered fundamentally important to all customers of this product:
● Install all required materials prior to delivery of the system.
● Complete the floor, ceiling and walls of the room before installing the equipment.
● Install proper sized junction boxes, with covers, at the necessary locations.
● Install a mains power with the proper voltage output and an adequate kVA rating.
● Install the circuit breaker specified by this manual.
● Provide the installer(s) with the current dimensions of the room including the hall way and entry
door sizes.
● The customer must have an electrician install more than two power outlets in the room.