5. Service Mode
EzRay Air Portable
(Model: VEX-P300) User Manual 51
EN
G
L
ISH
5.3.5
Angle Increments Setting
Available only in countries that allow the auto mode for use.
The mode is not available in the United Kingdom, the United
States, and some countries (Consult the sales representative
in your country for details). When the auto button is pressed,
only “NA” is displayed on the panel.
Follow the procedure below to set up the angle increments for the
Auto Mode
.
Service Mode No.
Item
n.18
Angle increments setting
When using the Auto Mode, the angle value increases and decreases according to the
increments setting (default: 1 degree).
The angle increments can be set
from
1 to
5 degrees
.
To change the angle increments setting,
1.
Select
n.18
and press the jog dial. The default angle increments
“001°”
is
displayed on the control panel, as shown in the right figure.
2.
Turn the jog dial to adjust the angle increments you want.
3.
Press the dial again and hold it until you hear a beep.
4.
Restart the device to check if the setting is saved correctly.
