Please call for replacement parts or assistance:
1-866-942-5362
VAS Furniture Mfg. Inc.
Factory No. 33-10944
Page # 17
MOUNTING FRAME on BRICK, SOLID CONCRETE OR BLOCK
24.
Use the Mounting Frame (part J) as a template to mark six holes
location in the wall, three in the top row and three in the bottom
row of slots.
25.
Make sure that the holes are level and there is at least 6” between
any two holes, pre-drill these holes with a 1/2” masonry bit to at
least 2 1/2” in depth.
26.
Now insert a Concrete Anchor (part 9) into each of these holes;
make sure the anchor is seated completely flush with the concrete
surface even if there is a layer of drywall of other material in front.
27.
Now attach the Mounting Frame (part J) to the Wall using six Lag
Bolts (part 10) through the Lag Bolt Washer (part 11) through the
slot of “U” Plate on Mounting Frame into the holes in the wall.
Make sure the Bracket is oriented so the flat surface in the center
of the plate is against the wall and that a set of Lag Bolts is on
each side of the center rail as shown in detail #14, only in this
case will have three Bolts per side. See detail #15.
28.
Repeat steps 13 to 16 to attach the Plasma TV onto the Mounting
Frame.
Parts Required
J – Mounting Frame (1)
9 –Concrete Anchor (6)
10 – Lag Bolt
(6)
11 – Lag Bolt Washer
(6)
Tools Required
Mallet, Power Drill, 1/2” Masonry Bit and Open Wrench
