Varimixer V150PLM, Operating Instructions Manual

Page: 8 / 36

8
Fig.5
Maintenance and lubrication:
The infinitely variable gear must be lubricated regularly, i.e. a lubrication interval of approx. 60 hours of operation.
Lubrication of infinitely variable gear:
OBS . Special grease !!(Use the grease gun delivered together with the mixer). Start the mixer and increase the speed
to approx. 50%. Stop the mixer and disconnect the power cable. Open the lid on the top of the mixer. On the top of each
of the two pulley set shafts is a grease nipple (fig. 5) . Press grease through the grease nipple until the grease gun feels
hard to press or until grease comes out between the shaft and the pulleys.
The mixer must not be started until the lid is closed and the screws which hold the lid are inserted.
Start the mixer, and set the speed back to low speed.
Stop the mixer and fill the grease gun with new grease so that it is ready for next time.
Lubrication of other movable parts:
The movable parts of the bowl arms as well as the shaft must be lubricated with oil.
Disconnect the power cable. Remove the rear covering and lubricate the marked points with an oil can.
(fig.5a)
Grease types:
Pulley set shafts: TOTAL MULTIS XHV 2.
Planetary head: Only to be repaired by an authorised technician.
Toothed wheel and the toothed rim special grease Nye FLUROCARBON GEL 868.
Needle bearings Special grease PN Sapphire 2.
Do not use any another type of grease than the one stated here.
Fig.5a