Error codes and possible solutions:
For some errors, the control system will show an error code in the display:
[ EE:1 ] User pressed
without raising the bowl to working height.
Solution:
Raise bowl to working height.
[ EE:2 ] User pressed
without fitting the safety guard.
Solution:
Fit the safety guard.
[ EE:4 ] The Thermal sensor in the motor has overheated.
Solution:
The error will disappear when the temperature has dropped to an acceptable level.
Stop the mixer and reduce the quantity of ingredients in the bowl. When it starts again, select a lower speed
.
[ EE:6 ] There is an error in communication between the control panel and the VFD (variable frequency drive).
Solution:
Please contact a technician for assistance.
[ EE:7 ] Error in VFD (variable frequency drive).
Solution:
Please contact a technician for assistance.
[ EE:8 ] Thermal sensor in the VFD (variable frequency drive) has cut out.
Solution:
The error will disappear when the temperature has dropped to an acceptable level.
[ EE:9 ] Intermittent low voltage in the power supply.
Solution:
Contact a technician to control the power supply to the mixer.
[ EE:10 ] Intermittent high voltage in the power supply.
Solution:
Please contact a technician for assistance
[ EE:14 ] Wrong parameter in VFD (variable frequency drive).
Solution:
Please contact a technician for assistance
- Varimixer instruction 23020-1602
[ OL:1 ] The mixer is overloaded - continuously for 50 seconds
Solution:
Reduce the quantity in the bowl; alternatively, the product may need to be divided into smaller parts
or diluted before the machine is restarted. When restarted, select a lower speed, if speed was the problem
The error code is removed by pressing
[ OL:2 ] The mixer is overloaded - momentarily (overloaded 8 times within 20 seconds
Solution:
Reduce the quantity in the bowl; alternatively, the product may need to be divided into smaller parts
or diluted before the machine is restarted. When restarted, select a lower speed, if speed was the problem.
The error code is removed by pressing
[ OL:3 ] Blockage.
Solution:
Remove the object that caused the blockage.
The error code is removed by pressing
,
and
can also occur when using the attachment drive.
13
