Varifan CPS-2C, Installation & User Manual

Page: 32 / 42

CPS-2C USER’S GUIDE
Section C-32 CPS-2C
RF Network
rf nt
This parameter is used to identify a WiFarm network. A WiFarm network is
formed when the
RF Network is set to the same value as the RF Address
of the RF communication card of the controller designated to be the network
master (ex. WebGate in most installations). Other controllers can join the
existing network by adjusting RF Network to the RF Address of that same
network. This parameter is adjusted digit-by-digit, allowing faster
modification for very high numbers. Press the SET/CLR button so that the
parameter’s first digit blinks. Modify that digit using the adjustment knob.
Press the F2 button to navigate through the different digits. Press the
SET/CLR button once again to end parameter modification. This parameter
can be adjusted to any value from 0 to 32767.
RF Address
rf Ad
This parameter displays the number (address) associated to the RF card
inserted in the controller. A unique number is given to each RF card of the
WiFarm network. There is a unique RF Address associated to each RF
card. The RF Address also appears on the sticker present on the RF card.
The address can be any value from 0 to 32767.
Tech Param Display
tpdis
This parameter is reserved for the manufacturer’s technical support
personnel.
Tech Param Result
tPres
This parameter is reserved for the manufacturer’s technical support
personnel.
Unit ID U Id
This parameter is used to select the identification number that will be used
when communicating with the remote access software. Each controller must
have a unique PC identification number. This parameter may be adjusted to
any value from 1 to 250.
(POS 11)
Configuration Version
CONF
This parameter displays the version of the configuration actually used.
Processor Version Proc
This parameter displays the version of the processor actually used.
(POS 12)
System Parameters
SYSTM
This parameter indicates that the CPS-2C is in system parameter mode.