CPS-2C INSTALLATION
Section B-16
CPS-2C
Uploading the Configuration
It is possible to upload a configuration into a configuration chip (MMX) in order to
save parameters and setup or to backup the configuration.
Here’s the procedure to upload a configuration.
A. Make sure that the CPS-2C powered up.
B. Remove the faceplate screws and lift up the cover.
C. Place the MMX chip into the socket of the main board. At this moment, the
MMX Detected
parameter will appear.
D. Adjust the
MMX Detected
parameter to
upLD
and press the SET/CLR
button. The display on the front panel should indicate
upLD
for
approximately 15 seconds. If
upLD
is not displayed, try one more time. If
upLD
is still not displayed, remove and replace the configuration chip
(MMX).
E. When the uploading procedure is complete, remove the configuration chip
(MMX) and place it in the bottom part of the enclosure or in another safe
location. Once the MMX Chip is removed, the CPS-2C will continue to
execute the configuration.
WARNING: During this procedure, some components are live and can
be dangerous if touched.
Summary of Contents for CPS-2C
Page 3: ...CPS 2C WIRING DIAGRAM CPS 2C Section A 3 WIRING DIAGRAM CPS 2C SECTION A ...
Page 7: ...CPS 2C INSTALLATION CPS 2C Section B 7 INSTALLATION CPS 2C SECTION B ...
Page 20: ...CPS 2C USER S GUIDE Section C 20 CPS 2C USER S GUIDE CPS 2C SECTION C ...
Page 38: ...CPS 2C INDEX WARRANTY INDEX WARRANTY CPS 2C SECTION D ...
