TECHNICAL INFORMATION
61
87-900-862-01(G)
Screw the flange mod. 969-9109 on the pump, tak-
ing care of the o-ring right position.
Assemble the seal ring and lock the vent device in
position using the KF klamp.
VIBRATION ISOLATOR INSTALLATION
A vibration damper model 969-9340 for ISO 63
inlet flange version pump is available as accesso-
ries.
It typically reduces the vibration transmitted from
the Turbo-V 70LP pump to the system by a factor
of 20.
Please refer to the relevant instruction manual.
TYPICAL LAYOUT DIAGRAM
1. Turbo-V
controller
2. Vent
valve
3.
Vacuum pump shut-off valve (optional)
4.
System vent valve (optional)
5. Vacuum
chamber
6. Ionization
gauge
7.
Fore-vacuum pump connecting flange
8.
Oil mist eliminator
9. Fore-vacuum pump with internal one-way
valve
10. Fore-vacuum pump control relay
11. Connection for water cooling
12. Roughing line with valve (optional)
13. Turbopump
Connection A - HIGH VACUUM FLANGE
To connect the Turbo-V70LP pump to the ISO inlet
flange, remove the outer ring and position the cen-
tering ring as shown in the figure.
Then fix the two flanges with the clamps or claws
as shown in the figure.
